2.2.8.1.1.1 Connecting the Inputs
The Phase and Ground Current Measuring Input Card supports both pin-terminal
connections and ring-terminal connections.
For either connection type, the rst step is to remove the
terminals from the device by opening the screws.
Remark: This removable part is a shorting block.
For the pin-terminal connection type, insert the cables and
fasten them by the screws that are located at the side of the
input card.
Attention should be paid to the tightening torque, ╚═▷ Fig. .
For the ring-terminal connection type, there is one intermediate
step to be done.
83www.eaton.comEMR-3MP0
2 Hardware
2.2 EMR-3MP0 – Installation and Wiring
To Next Page
Loading...
