Move the slider aside, so that the screws and metal plates
become fully accessible.
Every terminal consists of a screw with a non-losable metal
contact. Screw (plus contact) can be unscrewed completely.
After removing screw and contact you can insert the ring. Then
re-insert screw plus contact so that the screw goes through the
ring. Tighten the screw.
Attention should be paid to the tightening torque, ╚═▷ Fig. .
Finally move the slider back into its “closed” position.
Remark: As long as the cable cross-sections are within the limits
given in the Technical Data chapter (╚═▷ “Technical Data
EMR-3MP0”, ╚═▷ Tab. ) it is also possible to insert two rings into
one terminal, as shown here. This is useful for setting up the
neutral point connection.
84 www.eaton.com EMR-3MP0
2 Hardware
2.2 EMR-3MP0 – Installation and Wiring
To Next Page
Loading...
