Eaton Network-M2 - Page 101

Settings
Contextual help of the web interface – 101
•
•
•
a Manual
Select Manual, and then enter the network settings if the network is not configured with a BootP or DHCP server.
Enter the IP Address.
The Network Modulemust have a unique IP address for use on a TCP/IP network.
Enter the netmask.
The netmask identifies the class of the sub-network the Network Module is connected to.
Enter the gateway address.
The gateway address allows connections to devices or hosts attached to different network segments.
b DHCP
Select dynamic DHCP to configure network parameters by a BootP or DHCP server.
If a response is not received from the server, the Network Module boots with the last saved parameters from the most recent
power up. After each power up, the Network Module makes five attempts to recover the network parameters.
3.7.4.1.2 IPv6
IPV6 status and the first three addresses are displayed.
Press theEditbutton toconfigure the network settings and get more information and access to the following IPV6 details.