Eaton Network-M2 - Access Rights Per Profiles; Troubleshooting

Controls
Contextual help of the web interface – 51
•
This control is available only if the status is not OFF and if there are no active commands running.
Switch ON
This will switch ON the load connected to the associatedload segment.
This control is available when status is OFFand if there are no active commands running.
3.4.2.3 Pending action
Displays the delay before shutdown and delay before startup.
3.4.3 Access rights per profiles
Administrator Operator Viewer
Control
3.4.3.1 For other access rights
3.4.4 Troubleshooting
Action not allowed in Control/Schedule/Power outage policy
Symptom
Below message is displayed when you access the Control, Schedule or Power outage policy page.
This action is not allowed by the UPS.
To enable it, please refer to the user manual of the UPS and its instructions on how to configure the UPS settings and allow
remote commands.
Possible Cause
1- Remote commands are not allowed due to the UPS configuration (see the action below)
2- The UPS does not support remote commands.
Action
Refer to the UPS user manual and its instruction on how to configure the UPS settings and allow remote commands.
Example: UPS menu Settings>>>ON/OFF settings>>>Remote command>>>Enable.
3.4.4.1 For other issues
For other access rights, see the Information>>>Access rights per profiles section.
For details on other issues, see the Troubleshooting section.