Eaton Network-M2 - Controls

Controls
Contextual help of the web interface – 49
•
•
3.3.7.1 For other settings
3.3.8 Access rights per profiles
Administrator Operator Viewer
Meters
Battery health: Launch test/Abort
Logs configuration
3.3.8.1 For other access rights
3.4 Controls
3.4.1 Entire UPS
Controls are displayed for the entire UPS, and not for specific outlet options.
The table in this section displays UPS status, the associated commands (on/off), and the pending action.
3.4.1.1 Status
Reflects the current mode of the UPS.The following is a list of potential table values that are displayed based on the UPS topology.
On— Protected/Not protected
Off— Not powered/Not protected
3.4.1.2 Commands
A setof commands are available and activated when one of the followingbuttons is pressed.A confirmation window appears.
For other settings, see the Information>>>Default settings parameters section.
For other access rights, see the Information>>>Access rights per profiles section.