Eaton Network-M2 - Page 216

 Default settings and possible parameters
Information – 216
•
•
•
•
Default settings and possible parameters - Network & Protocol
Default setting Possible parameters
IPV4 Mode — DHCP Mode — DHCP/Manual (Address/Netmask/Gateway)
IPV6 Enable — checked
Mode — DHCP
Enabled — Active/Inactive
Mode — DHCP/Manual (Address/Prefix/Gateway)
DNS/DHCP Hostname — device -[MAC  address]
Mode — DHCP
Hostname — 128 characters maximum
Mode :DHCP/Manual (Domain name/Primary DNS/
Secondary DNS)
Ethernet Configuration — Auto negotiation Configuration — Auto negotiation - 10Mbps -Half
duplex - 10Mbps -Full duplex - 100Mbps - Half duplex
- 100Mbps -Full duplex - 1.0 Gbps - Full duplex
HTTPS Port — 443 Port — x-xxx
Syslog Inactive
Server#1
Name – Primary
Status – Disabled
Hostname – empty
Port – 514
Protocol – UDP
Message transfer method – Non transparent framing
Using unicode byte order mask (BOM)– disabled
Server#2
Name – empty
Status – Disabled
Hostname – empty
Port – 514
Protocol – UDP
Message transfer method – DIsabled in UDP
Using unicode byte order mask (BOM)– disabled
Inactive/Active
Server#1
Name – 128 characters maximum
Status – Disabled/Enabled
Hostname – 128 characters maximum
Port – x-xxx
Protocol – UDP/TCP
Message transfer method – Non transparent framing
Using unicode byte order mask (BOM)– disable/
enable
Server#2
Name – 128 characters maximum
Status – Disabled/Enabled
Hostname – 128 characters maximum
Port – x-xxx
Protocol – UDP/TCP
Message transfer method (in TCP)– Octet counting/
Non transparent framing