Eaton Network-M2 - Web user interface is not up to date after a FW upgrade

Web user interface is not up to date after a FW upgrade
Troubleshooting – 267
•
•
8.11.2 Action
Recover the IP address and connect to the card.
Refer to Installing the Network Management Module>>>Accessing the Network Module>>>Finding and setting the IP address
section.
8.12 Web user interface is not up to date after a FW upgrade
8.12.1 Symptom
After an upgrade:
The Web interface is not up to date
New features of the new FW are not displayed
8.12.1.1 Possible causes
The browser is displaying the Web interface through the cache that contains previous FW data.
8.12.1.2 Action
Empty the cache of your browser using F5 or CTRL+F5.