Eaton PowerXL DC1 Series - Page 52

3 Installation
3.2 Mounting
46 DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com
3.2.3.2 Fixing on mounting rails
As an alternative to screw fixing, DC1 variable frequency drives with sizes
FS1 and FS2 and a degree of protection of IP20 can also be mounted on a
mounting rail as per IEC/EN 60715.
Figure 23: Mounting rail conforming with IEC/EN 60715
 To do this, place the variable frequency drive on the mounting rail from
above [1] and press it down until it snaps into place [2].
Figure 24: Fixing on mounting rails
[mm] [in]
￫
If you use EMC mounting adapters (DX-EMC-MNT-…), use a tall
mounting rail (15 mm) preferably.
35
1
7.5
15
1.38”
0.04”
0.29”
0.59”
2
1
VAR
EMC
VAR
EMC