Eaton PowerXL DC1 Series - Page 53

3 Installation
3.2 Mounting
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 47
Dismantling from mounting rails
 To remove the device, push down the spring-loaded clip. A cutout
marked on the lower edge of the device is provided for this purpose.
A flat-bladed screwdriver (blade width 5 mm) is recommended for
pushing down the clip.
Figure 25: Dismantling from mounting rails
2
1
3
VAR
EMC
f 5 mm
(f 0.197“)