EBS EBS-6100 - Page 85

EBS
Ink-Jet Systems
®
 EBS-6100 Printer User's Manual
 Paragraph 4 - Operating the Printe
r
20070529#20.5
 83
Alarm LED
Message on the terminal display
Description
LED
V1/V7 ERR.
EBS-6000
EBS
A V1 valve failure (the valve does not close completely) in
printers whose ink system is equipped with a pump. The
valve needs replacing or repairing. Contact a service
point.
LED
FILL.ERR./
PRESS.DROP
INK PRESSURE DROP
EBS-6000
EBS
A time-out error while setting the nominal pressure of ink
in the ink system or a sudden pressure drop below its
nominal setting (PRESS.DROP).
The failure can be caused by the following:
• The main ink filter is dirty - replace the filter - the
operation can be performed by the user with no
service assistance.
• A leakage in the ink system, damaged ink pump or
elements of pump control. Contact a service point.
LED
SOLV. BAD
NO SLV TO CLEAN
EBS-6000
An error does not exist.
LED
INK LACK
INK:
EMPTY BOTTLE
EBS-6000
REPLENISHMENT ERROR and
INK LACK
EBS-6000
EBS
No ink can be sucked from the ink bottle.
Supply ink by replacing the empty bottle with a full one. If
no new bottle is validated within 20 minutes of the
indication of the error, the printing stops and the following
message is displayed:
REPLENISHMENT ERROR
Replace the empty ink bottle with a new full one.
No ink can be sucked by the system although a new bottle
of ink has been validated. The message can be generated
for the following reasons:
• the operator has not inserted any filter-tipped suction
pipe into the bottle and has not screwed the bottle in
place,
• leaky pipes or clogged ink filter at the tip of the suction
pipe,
• leakage or damage to other elements that are
responsible for refilling the system with ink from the
bottle.