Edimax CAP1300 - Page 176

Edimax Pro NMS
176
Fragment
Threshold
Set the fragment threshold of the wireless radio. The default
value is 2346.
Multicast
Rate
Set the transfer rate for multicast packets or use the “Auto”
setting.
Tx Power
Set the power output of the wireless radio. You may not
require 100% output power. Setting a lower power output can
enhance security since potentially malicious/unknown users
in distant areas will not be able to access your signal.
Beacon
Interval
Set the beacon interval of the wireless radio. The default
value is 100.
Station idle
timeout
Set the interval for keepalive messages from the access point
to a wireless client to verify if the station is still alive/active.
WDS Settings
WDS
Functionality
A wireless distribution system (WDS) is a system enabling the
wireless interconnection of access points in an IEEE 802.11
network. It allows a wireless network to be expanded using
multiple access points without the traditional requirement for
a wired backbone to link them.
AP Device
Name
Set AP Device Name.
MAC Address
Set MAC Address of AP.
WDS VLAN
Mode
Enable / Disable VLAN function.
WDS VLAN ID
Set VLAN ID of WDS.
WDS
Encryption
Set WDS Encryption.