Edimax CAP1300 - Command Line Interface; XI-2-1 Config

316
XI-2 Command Line Interface
Settings can also be configured using the Command Line Interface using the
steps and commands shown below:
Edit Mode
1. Log on this product.
2. Enter the “edit start” command.
man$ edit start
3. The change of prompt from "man $" to "man [edit] $" indicates that Edit Mode is initiated.
man[edit]$
In Edit Mode, if more than one command is entered, you can reflect the settings using the following:
man[edit]$ wlan 5g band 11a11n brs 24m channel 40 bandwidth 40m+ex_lower_ch
man[edit]$ config timezone 50 man[edit]$ edit end
When you run the “edit end” command exit Edit Mode, the setting will be achieved.
XI-2-1 Config
config apname
Name / rename this product.
<Syntax of the command>
config apname (apname)
- <Parameter>
(apname) – name of the product
- <Default configuration>
AP (MAC address LAN side of this product)
- <Command mode>
Immediate Mode, Edit Mode
- <Compatible Products>
CAP1300
- <Examples>
# config apname enterprise-network
config basic_info show status
Show the configuration information setup.
<The syntax of the command>
config basic_info show status { admin|buzzer|date&time | led_settings | syslog_server }