Edimax CAP1300 - XI-2-6 Exit

360
- <Command mode>
Immediate Mode, Edit Mode, Reference Mode
- <Compatible Products>
CAP1300
- <Examples>
# radius internal termination_action not_reauth
radius show status
Show the radius information.
<The syntax of the command>
radius show status
- <Parameter>
NA
- <Default configuration>
NA
- <Command mode>
Immediate Mode, Edit Mode, Reference Mode
- <Compatible Products>
CAP1300
- <Examples>
# radius show status
XI-2-6 Exit
exit
Quit the CLI.
<The syntax of the command>
exit
- <Parameter>
NA
- <Default configuration>
NA
- <Command mode>
Immediate Mode
- <Compatible Products>
CAP1300
- <Examples>
# exit