AP, Managed AP, Repeater & Client Bridge Modes
33
IV Basic Settings
Basic settings of the access point are:
- LAN IP Address; and
- 2.4GHz & 5GHz SSID & Security; and
- Administrator Name & Password; and
- Time & Date
It is recommended that these settings are configured before using the
access point.
Whenever a new setting is applied to the access point, the webpage will
reload, as shown below:
Instructions below will help you configure these settings:
Changing IP Address:
1. Go to “Network Settings” > “LAN-side IP Address” for the screen
below:
If you are unable to configure any settings here, please make sure the
operation mode of the Access Point is in “AP Mode”. Please refer to VI-6
Operation Mode for more information.
To Next Page
Loading...
