AP, Managed AP, Repeater & Client Bridge Modes
51
VI-2-2 LAN Port
“LAN Port” page allows you to configure the settings for your access point’s
two wired LAN (Ethernet) ports.
Identifies LAN port 1 or 2.
Enable/disable specified LAN port.
Select a speed & duplex type for specified LAN port, or use
the “Auto” value. LAN ports can operate up to 1000Mbps and
full-duplex enables simultaneous data packets
transfer/receive.
Enable/disable flow control. Flow control can pause new
session request until current data processing is complete, in
order to avoid device overloads under heavy traffic.
Enable/disable 802.3az. 802.3az is an Energy Efficient
Ethernet feature which disables unused interfaces to reduce
power usage.
Press “Apply” to confirm the settings.
To Next Page
Loading...
