Edimax CAP1300 - Page 183

Edimax Pro NMS
183
Fragment
Threshold
Set the fragment threshold of the wireless radio. The default
value is 2346.
Multicast
Rate
Set the transfer rate for multicast packets or use the “Auto”
setting.
Tx Power
Set the power output of the wireless radio. You may not
require 100% output power. Setting a lower power output can
enhance security since potentially malicious/unknown users
in distant areas will not be able to access your signal.
Beacon
Interval
Set the beacon interval of the wireless radio. The default
value is 100.
Station idle
timeout
Set the interval for keepalive messages from the access point
to a wireless client to verify if the station is still alive/active.
X-5-1-2-5 Edit WMM-EDCA Settings