Edimax CAP1300 - Page 286

Edimax Pro NMS
286
Advanced Settings
Product Name
Edit the product name according to your preference
consisting of 1-32 alphanumeric characters. This name is used
for reference purposes.
Management
Protocol
Check/uncheck the boxes to enable/disable specified
management interfaces (see below). When SNMP is enabled,
complete the SNMP fields below.
SNMP Version
Select SNMP version appropriate for your SNMP manager.
SNMP Get
Community
Enter an SNMP Get Community name for verification with the
SNMP manager for SNMP-GET requests.
SNMP Set
Community
Enter an SNMP Set Community name for verification with the
SNMP manager for SNMP-SET requests.
SNMP Trap
Enable or disable SNMP Trap to notify SNMP manager of
network errors.
SNMP Trap
Community
Enter an SNMP Trap Community name for verification with
the SNMP manager for SNMP-TRAP requests.
SNMP Trap
Manager
Specify the IP address or sever name (2-128 alphanumeric
characters) of the SNMP manager.
HTTP
Internet browser HTTP protocol management interface
TELNET
Client terminal with telnet protocol management interface
SNMP
Simple Network Management Protocol. SNMPv1, v2 & v3 protocol supported.
SNMPv2 can be used with community based authentication. SNMPv3 uses
user-based security model (USM) architecture.
Press “Apply” to apply the configuration.