TP-00347-01 101
Error Codes
57 Error during rotation to end position
60 Move from/to drive failed
61 Error during first slider movement
62 Error during first gripper movement
63 Error during second slider movement
64 Error during second gripper movement, get range failed
65 Error during third slider movement, move home failed
70 Release magazine failed
71 Error during sled movement to rotation position
72 Error during rotation to unlock position
73 Error during move sled to block
80 Opening mailslot failed
81 Error during movement to mailslot open position
82 Error during moving back - sensor was found
90 Movement to home position failed
91 Elevator movement to home position failed
92 Error during sled movement to rotation position
93 Error during rotation to home or far position
94 Sled movement to home sensor position failed
95 Sled movement to transport position failed
99 Error during rotation movement to rotation min position
A0 Movement to mailslot failed
A1 Sled movement to sensor failed
A2 Sled movement to rotation position failed
A3 Elevator movement to home position failed
A4 Error during rotation to far position
A5 Sled movement to mailslot posi
tion failed
A6 Error during elevator movement to position
A7 Error during mailslot detection
B0 EEPROM on media changer controller not accessible or error
dur
ing r/w operation
B1 Save/restore configuration settings: no
t enough internal memory
available for creating the file
and restoring the file respectively
B2 Save/restore configuration settings: restore buffer corrupted,
c
hecksum calculation failed
B3 Save/restore configuration settings: data base field corrupted
B4 Save/restore configuration settings: invalid personality
B5 Save/restore configuration settings: invalid file
Code Description
To Next Page
Loading...