EditShare 24Q - Page 90

90 TP-00347-01
Chapter 6: Troubleshooting
88 Setting of sled motor parameters
failed
Reset the unit and retry
operation. After several
occurrences contact technical
support
Media changer probably
def
ective.
Media changer controller defect.
89 Gripper blocked Run 'Library Verify Test', after
sev
eral occurrences contact
technical support
Media changer probably
defective.
Gripper motor not connected or
def
ect.
Gripper motor voltage too low.
Media changer controller or
distr
ibution boards defect.
Check gripper mechanism
ac
cording stiffness in movement.
8A Slider blocked Run 'Library Verify Test', after
sev
eral occurrences contact
technical support
Media changer probably
defective.
Slider Motor not connected or
def
ect.
Slider motor voltage too low.
Media changer controller or
distr
ibution boards defect.
Check slider mechanism
ac
cording stiffness in movement.
8B Elevator blocked Run 'Library Verify Test', after
sev
eral occurrences contact
technical support
Media changer probably
defective.
Elevator motor not connected or
def
ect.
Elevator motor voltage too low.
Media changer controller or
distr
ibution boards defect.
Check elevator mechanism
ac
cording stiffness in movement
8C Rotation blocked Run 'Library Verify Test', after
sev
eral occurrences contact
technical support
Media changer probably
defective.
Rotation motor not connected or
def
ect.
Rotation motor voltage too low.
Rotation home sensor defect.
Rotation sensor connecting
cable damaged
.
Media changer controller or
distr
ibution boards defect.
Error
C
ode Description User Action Critical Component Status