EditShare 24Q - Page 91

TP-00347-01 91
Error Codes
8D Sled blocked Run 'Library Verify Test', after
several occurrences contact
technical support
Media changer probably
defective.
Sled motor not connected or
def
ect.
Sled motor voltage too low.
Sled home sensor defect.
Sled sensor connecting cable
damaged
.
Media changer controller or
distr
ibution boards defect.
Check sled mechanism (guide
rail
, ducktail) according stiffness
in movement.
8E Cannot find gripper block within
th
e expected range
Run 'Library Verify Test', after
several occurrences contact
technical support
Media changer probably
defective.
Elevator distribution board
def
ect.
Cabling incorrect.
Check gripper gears.
8F Cannot find slider block within
th
e expected range
Run 'Library Verify Test', after
several occurrences contact
technical support
Media changer probably
defective.
Elevator distribution board
def
ect.
Cabling incorrect.
Check slider gears.
90 Cannot find elevator block within
th
e expected range
Run 'Library Verify Test', after
several occurrences contact
technical support
Media changer probably
defective.
Elevator distribution board
def
ect.
Cabling incorrect.
Check elevator gears.
91 Cannot find rotation block within
th
e expected range
Run 'Library Verify Test', after
several occurrences contact
technical support
Media changer probably
defective.
Cabling incorrect.
Check rotation gears.
92 Cannot find sled block within the
expe
cted range
Run 'Library Verify Test', after
several occurrences contact
technical support
Media changer probably
defective.
Cabling incorrect.
Check sled gears.
93 Gripper outside range,
Gripper has reached a position
bey
ond the expected range
Run 'Library Verify Test', after
sev
eral occurrences contact
technical support
Media changer probably
defective.
Elevator distribution board
def
ect.
Cabling incorrect.
Check gripper gears.
Error
C
ode Description User Action Critical Component Status