87 Installation and Service Guide: Printer Controller EB-34
Installing System Software
The System Software installation takes approximately 1.5 hours to complete.
1 Insert System Software DVD 1 into the DVD drive.
2 Reboot the EB-34.
Wait while the system boots from the DVD.
3 When the language selection screen displays, select a language.
4 When “What do you want to do?” screen displays four choices, select New Installation.
5 When “This installation will erase all data on the hard disk drive(s). Continue?” message displays, select Continue.
6 After copying the System Software DVD 1 contents to the hard drive, the DVD ejects (approximately five to seven
minutes), insert System Software DVD 2.
7 After copying the System Software DVD 2 contents to the hard drive, the DVD ejects (approximately five to ten
minutes), insert System Software DVD 3.
8 After copying the User Software DVD 3 contents to the hard drive, the DVD ejects (approximately eight minutes),
insert User Software DVD 4.
When User Software DVD 4 ejects (approximately eight minutes after copying the contents to the hard drive), the
EB-34 reboots to begin the software installation.
9 Wait while the EB-34 complete the installation. This will take about 45 minutes.
The following steps are for use with the Fiery Advanced Controller Interface. If you are not using this interface, skip
to step 12.
10 When the EB-34 becomes Idle, click the mouse to show the login screen on monitor. Enter the Administrator’s
password and then press Enter.
Fiery.1 is the default password and is case-sensitive.
11 Ask the site administrator to follow the on-screen instructions in the Fiery Setup Wizard to configure the EB-34 for
the customer’s print environment.
Once the configuration in the Fiery Setup Wizard is done, you must restart the server for the changes to take effect.
If desired, you can print a Server Configuration page after the restart to confirm the default settings.
For more information about the Fiery Setup Wizard, see Configuration and Setup, which is part of the user
documentation.
12 Shut down the EB-34 (see page 28).
After installing or updating the system software
1 Restore the dongles and devices that you removed in a previous step.
2 Start the EB-34 (see page 28).
3 Install any required software patches by System Updates (see page 89).
To Next Page
Loading...
Need help?
General
