Electrolux T4900 - Measuring Supply Pressure

Gas system
Service
manual
102
Measuring tap, supply pressure (pos. 6)
Seetheinstallationmanualforthepropersupplypressureforthe
gastypebeingused.
1.Turnoffthedryerandthemanualgasvalve.
2.Loosenthegaspressuretap(pos.6)one-quarterofaturnand
connectamanometertothetap.
3.Turnonthemanualgasvalve.
4.StartthedryeronHighheatandcheckthatthesupplypressureis
withintheallowablerange.
Note! Ifthepressureisnotwithintherangespecifiedinthe
installationmanual,
DO NOT OPERATE THE DRYER.
Contactyourgassupplier.
NOTEthatthegassupplyMUSTbeturnedoffbefore
looseningtappos.6(SUPPLY)orgaswillescape.