Electrolux T4900 - Replacing and Programming the Control PCB

39
Control
Service
manual
TheSelectaIIPCBisnotserviceable.Itmust
bereplacedifitfails.
TheSelectaIIPCBcanbeorderedasaspare
part.
Thesparepartconsistsof:Circuitboardwith
fusesinanti-staticpackingandinstructions.
Followtheinstructionswhenreplacingthemain
circuitboard.
ThenewSelectaIIPCBispre-programmed
withspecificfeaturesandmayneedtobe“post-
programmed”afterinstallation.
Inordertostarttheprogramming,the
programmingmodehastobeentered,seethe
followingpage.
Following settings must be programmed:
•Reversing(YesorNo) 4.01
•Heatingtype(gas,electricorsteam)4.02
•Paymentsettings(Nopayment) 4.03
•Paneltype(OPL) 4.04
•Programtype(OPLRMC,AutoStop) 4.05
Selecta Control Service Manual
Certainmaincircuitboardparametersneed
tobesetafterinstallation,accordingtothe
characteristicsofthedryerandthepreferences
oftheowner.
SeeSelectaControlServiceManualforfurther
details.
Replacement of Selecta II PCB