Electrolux T4900 - Gas Error

67
Heating - gas
Service
manual
Gas error
Fig.1ShouldagaserroroccurerrorcodeE 14
willbedisplayed.
Ingeneral,gaserrorsoccurduetosupply
shortageeitherifthereisagasfailureorthegas
pressureistoolow.
OthererrorswhichcancauseE 14 :
•Ignitionfailure.Checkthedistancebetweenthe
 electrodesononeburner,fig.2.
 Thedistancemustbe3.5mm(±0.5mm).
 Thedistanceabovetheburnermustbe5mm
 (±0.5mm).
•Fig.3ThesensorS ontheotherburner(the
 ionizationmustdetecttheflame).
Control measuring the ionization current
1.DemountwirewithquickconnectorA.
2.Fig.4a+bConnectanammeter/gauge 
 betweenthequickconnectorAandthe 
 ignitionelectrodeB.
3.StartthedryeronHighheat.
4.Measurethecurrentbetweenthequick 
 connectorAandtheignitionelectrodeB.
 Thecurrentmustbeatleast0.9µADC.
  Tobecontinued
P
487 19 24 03.02
3.5 mm ±0,5
5 mm
±0.5
5 mm
3.5 mm
S
B
4b
4a
A
A
B
1
3
2