Electrolux T4900 - Electric Heated Dryer Systems

Electric heated dryers
Description
Fig.1Theelectricheatingunitislocatedat
thetopofthedryerbehindbackplateA.
Theairisdrawnthroughthelouvresonthe
backplateandintotheheatingunit.
Theheatedairpassesthroughthegarments
andthedrumvents.
Fig.2Thentheairflowsfromtheperforation
throughthefilterandviatheoutlettotheopen
air.
Theheatingelementisswitchedonby
theheatingcontactorK4andK5,whichis
controlledby
theSelectaControl.
Overheating thermostats
AlsoseesectionSensors and overheating
thermostats.
Electricheateddryersareequippedwiththree
overheatingthermostatsconnectedinseries,
twointheinletandoneintheoutlet.
Intheeventofoverheating,thedryerstops
andE08flashesinthedisplay.
Resetmustbedonemanuallybutfirstthe
errormustbedetectedandtheswitched
offoverheatingthermostatmustbefound,
seesectionSensors and overheating
thermostats.
Thiserrorisoftencausedbyreductionofthe
aircirculationinthedryerduetonotenough
airintheroomorduetothedryerbeing
overloaded.
Ifthedryerisalsostoppedbeforethecool
downfunctionhasstartedtheafter-heatcan
causetheoverheatingthermostatstoswitch
off.
Thefollowingerrorcodeisrelatedtothis
section:
E 08 overheating
SeeSelectaControlservicemanual.
2
1
A
73
Heating - electric
Service
manual