Elspec G4500 BlackBox - Page 263

263
 Select Enable to enable the GPS’s use. The GPS Configuration section will confirm:
 The Time Stamp: Date & UTC Time
 Latitude: Geographic coordinate that specifies the north-south position of a point on the
Earth's surface.
 Longitude: Geographic coordinate that specifies the east-west position of the GPS on the
Earth's surface.
 Altitude: Geographic coordinate that specifies the vertical or "up" direction point of the GPS.
 Signal Quality: Displays the manner in which the GPS is synchronized to the signal. In this
case SPS – Standard Positioning Service.
 Status: Fixed means GPS is directed to the satellite. Not fixed – means that the GPS is not
directed to the satellite. Recheck your GPS connections again, including the Power Source (if
in use).
 Tracked Satellites: Number of satellites tracked by the GPS.
 Delay: If you are using a GPS other than the GPS supplied by Elspec you will need to toggle
the phase calculations of the GPS according to the product specifications.
 Satellite Details
 To apply your changes select to review your changes
SEE ALSO:
 Connect Serial Ports
 About Advanced Settings
 System Log
 Create Custom Events
 Events List
 E-Mail Alerts
 About Reports
 Energy Meter
 Display Setup
 Portable BLACKBOX Software (Firmware) Upgrade