For MV/HV Networks (Voltage Measurements by PT's) set the correct Primary &
Secondary Ratio (with /) – according to the PT Manufacturer's Specifications & not
just the Ratio:
Define the Nominal Values for Frequency (F) and Voltages (V) (with / ):
The ratio for LV Networks (<1kV) is based on the same concept & specifications:
Set the Primary & Secondary Ratio (with
/) –(according to the PT Manufacturer's
Specifications & not just the Ratio):
Define the Nominal Values for Frequency (F)
and Voltages (V) (with /):
To apply your changes select to review your changes
Go to the next step Current Configuration
NOTE NOTE NOTE
If you are not logged on as the Administrator, you will not be able to change any of these settings &
you will receive the following error message in your attempt to do so:
To Next Page
