Express Install for File OE release 7.0 or lower
213
NAS Install Options
EMC CONFIDENTIAL
The system prompts you to select the number of fibre switches to use
(Figure 128).
Figure 128 Number of Fibre Channel switches screen
26. Enter the number of switches and press Enter.
The system prompts you to enter information for switch 1 (Figure 129).
Figure 129 Fibre Channel switch 1 settings
27. Enter the Fibre Channel switch information, tab to OK, and press Enter. Get the
FC switch information from the “FC/FCoE cabling worksheet” on page 273.
The system prompts you to enter switch 2 information (similar to Figure 129).
28. If you selected to use more than one FC switch for the new array, the system
prompts you to enter information for the next switch (similar to Figure 129). Enter
the information, tab to Ok, and press Enter. Repeat for each FC switch.
29. If the VNX array has only two frontend ports on each SP, the system prompts you
for confirmation. If you get this prompt, go to step 32 on page 215.
To Next Page
Loading...
Need help?
General
