Emerson DCX S - Activating Ultrasonic Power

90 100-412-183 REV. 13
7.1 Activating Ultrasonic Power
On DCX S Power Supply, ultrasonic power activates after receiving an External Start signal
at the corresponding user I/O.
Ultrasonic power remains On until you turn off the power supply or the External Start
signal. For default user I/O assignment see 5.3.6 User I/O Connections For information on
configuring the power supply user I/O refer to your DCX S Power Supply Web Page
Interface Instruction Manual (100-412-187).
NOTICE
DCX S Power Supply must be in ready mode before External Start.