94 100-412-183 REV. 13
7.4 Configuring the Power Supply Registers
At power up the DCX S Power Supply will display the last amplitude setting, this is
indicated by the percentage icon (%) on the LCD. Refer to Figure 7.1 LCD at Power Up.
Table 7.3 Steps to configure the Power Supply Registers
Step Action Reference
1
Press the Configuration key until the
number icon (#) appears on the LCD.
The power supply will display register
101 the first time you access the
registers. (If you access the registers
again the last selected register will be
displayed).
2
Press and release the Up or Down arrow
keys to select the desired register. For a
detailed description of available
registers refer to Table 7.4 Power
Supply Registers.
3
Once you have reached the desired
register, press the Configuration key.
The register value will be displayed, this
is indicated by the circle icon.
To Next Page
Loading...
