100-412-183 REV. 13 67
5.5 Assembling the Acoustic Stack
CAUTION General Warning
The following procedure must be performed by a setup person. If
necessary, secure the largest portion of a square or rectangular horn
in a soft jawed vise. NEVER attempt to assemble or remove a horn by
holding the converter housing or the booster clamp ring in a vise.
CAUTION General Warning
Do not use silicone grease with Mylar plastic film washers. Use only 1
(one) Mylar plastic film washer of the correct inside and outside
diameters at each interface.
NOTICE
The use of a Branson torque wrench or the equivalent is
recommended. P/N 101-063-787 for 20 kHz, and 30 kHz systems
and 101-063-618 for 40 kHz systems.
To Next Page
Loading...
Need help?
General
