Emerson DL8000 - Page 159

DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-31
Cmd No
(decimal)
Cmd No
(hex)
Command Name
Valid modes
(Automatic/Manual)
Command
supported
Type
31 1F
Transaction data by
component
A/M Yes Read
32 20 Initialize Transaction Storage A/M Yes
33 21 Start Communication A/M Yes
34 22
Request program code
values and attributes
A/M Yes Read
35 23 Set program code value A Yes Write
36 24
Modify program code
attribute
A No
37 25
Request value changed
attributes
A No
38 26
Clear value changed
attributes
A No
39 27 Configure recipe A Yes Write
40 28 Get Date and Time A/M Yes Read
41 29 Set Date and Time A/M Yes Write
42 2A Request firmware version A/M Yes Read
43 2B Read input A/M No
44 2C Write output A/M No
45 2D DUART Diagnostic A/M No
46 2E ARCNET Diagnostic A/M No
47 2F Request crash data A/M No
48 30 Reset Unit A/M Yes
49 31 Last key pressed A/M Yes
50 32 RAM Tests A/M No
51 33 Swing arm side A/M Yes
Read (only
for version
2.0 and
later)
52 34 Installed boards A/M No
53 35 Configure A/M No
54 36 Weight & Measure Switch A/M Yes Read
55 37 Change operating mode A/M Yes
56 38 Clear display A Yes
57 39 Request stored transaction A/M Yes
58 3A Request stored batch A/M Yes
59 3B
Enhanced Start
Communications
A/M Yes Read
60 3C Enhanced Request Status A/M Yes Read
61 3D Report Alarm A/M Yes
The DanLoad 6000 protocol contains all the data required to execute the
command in the command request frame. However, some differences