Emerson DL8000 - Danload 6000 Protocol Commands

DL8000 Preset Instruction Manual
D-30 Communications Protocols Revised February-2016
D.3.2 DanLoad 6000 Protocol Commands
The following table lists the DanLoad 6000 protocol commands,
indicates which DanLoad 6000 protocol commands the DL8000
supports, designates the operating mode (automatic or manual) in which
the command is valid, and notes which commands which are purely
read or write.
Table D-2. DanLoad 6000 Commands
Cmd No
(decimal)
Cmd No
(hex)
Command Name
Valid modes
(Automatic/Manual)
Command
supported
Type
1 1 Prompt Recipe A Yes
2 2 Request Selected Recipe A Yes Read
3 3 Prompt Additives A Yes
4 4 Request Selected Additive A Yes Read
5 5 Timeout Operation A Yes
6 6 Authorize Transaction A Yes
7 7 End Transaction A Yes
8 8 Prompt Preset Volume A Yes
9 9 Request Preset Volume A Yes Read
10 A Authorize Batch A Yes
11 B Set Densities/Gravities A Yes Write
12 C Set Temperature A No
13 D End Batch A Yes
14 E Start/Restart Batch A Yes
15 F Stop Batch A Yes
16 10 Batch Data by Component A Yes Read
17 11 Additive Totalizer A/M Yes Read
18 12 Request Status A/M Yes Read
19 13 Clear Status A Yes
20 14 Reset Primary Alarms A Yes
21 15 Meter Totalizers A/M Yes Read
22 16 Component Totalizers A/M Yes Read
23 17 Unauthorized Flow A/M Yes Read
24 18 Data code value A/M No
25 19 Request Meter Values A/M Yes Read
26 1A Request Component Value A/M Yes Read
27 1B
Request Power Fail Date
and time
A/M Yes Read
28 1C Display Message A Yes
29 1D Request keypad data A Yes Read
30 1E
Request Transaction Storage
Status
A/M Yes Read