Emerson DL8000 - Invalid Recipe Selection; Additive Selection; Data Item Prompt; Messages

DL8000 Preset Instruction Manual
Revised February-2016 DL8000 Keypad Display E-7

14/02/12 13:58:59
Select from the
Following Recipes
(ENTER to Continue)
Recipe #1
Recipe #2
Recipe #3
Recipe #4
Recipe #5
E.2.2 Invalid Recipe Selection
If the select recipe fails verification, the DL8000 displays the Invalid
Recipe Selection screen:
Note: Refer to Table 2-4 for possible information on error
messages.

14/02/12 13:58:59
Invalid Recipe
(Info message)
(Press CLEAR)
E.2.3 Additive Selection
If the system has at least one additive, the DL8000 displays the
Additive Selection screen. The operator can then select the required
additives.

14/02/12 13:58:59
Press SELECT
To Choose
(ENTER to Continue)
Recipe #1
Additive 1 OFF
Additive 2 OFF
Additive 3 OFF
Note: This screen displays only if you defined Additive Selection
as a prompt. If you did not define Additive Selection as a
prompt or if you defined the additive within the recipe, the
DL8000 skips this screen and displays the Data Item Prompt
screen.
E.2.4 Data Item Prompt
If you have configured at least one data item, the DL8000 displays
the Data Item Prompt screen (where n indicates the data item).