Emerson DL8000 - Meter Totalizers (0 X15)

DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-47
Reset
Primary Alarms
[0x14]
Deviations
 Some DL8000 alarms may not map directly to
DanLoad 6000 alarms.
 Additional exceptions are supported such as
invalid alarm ID and Unable to reset the alarm.
 DL8000 allows reset of non-primary alarms;
DanLoad 6000 allows reset of only primary
alarms.
 Does not support the following DanLoad 6000
protocol alarms:
• Data logging memory full
• Memory Check Failure
• Primary Display Failure
• Secondary Display Failure
• MPMC 1 and MPMC 2 Failure
• Calibration Failure for all meters
• Intermediate Level Input
Meter Totalizers
[0x15]
Returns a non-resettable authorized flow from meter. In a blending
configuration (where more than one component may flow though a meter), it
is not always possible to determine which component generates unauthorized
flow.
Flags Immediately Set
None
Flags Immediately
Cleared
None
Exceptions
None
Supporting
Parameters
Preset delivery type [63,0,29]
Results
The response frame includes the following
parameter values:
 Number of meters [63,0,20]
 Meter Authorized Gross Total [75,x,15]
 Meter Authorized Net std or Mass Total
[75,x,17 or 18] based on delivery type
Deviations
The original DanLoad 6000-supported command
returns a snapshot of the free-running meter
totals. The DL8000 command returns free-running
authorized meter totals.
Component Totalizers
[0x16]
Returns non resettable component totalizers. In a blending configuration
(where more than one component may flow through a meter) it is not always
possible to determine which component generates unauthorized flow.
Flags Immediately Set
None
Flags Immediately
Cleared
None
Exceptions
None
Supporting
Parameters
Preset delivery type [63,0,29]