Emerson DL8000 - Status Flags Description [63,0,119; Status Flags; D.8 Status Flags Description [63,0,119]

DL8000 Preset Instruction Manual
D-80 Communications Protocols Revised February-2016
D.8 Status Flags Description [63,0,119]
The following table describes activities that set or reset status flags.
Table D-4. Status Flag Descriptions
Status Flag Flag sets when… Flag resets when…
Additive Selected
Operator selects additive through
keypad.
Note: If TAS writes additive
selection to [63,0,60] then
flag does not change.
 Transaction authorizes (in
manual mode)
 Authorize Transaction
command received (in auto
mode)
 Prompt Additive command
received.
 Additive selection screen is
prompted (in manual mode).
 Operating mode changes.
 DL8000 powers on.
 Clear Status command received
(in auto mode with bit 05h).
Batch Aborted (not started)
 Operator presses Stop key for
authorized batch after entering
preset volume (in manual
mode).
 Operator issues Stop Batch
command for authorized batch
which is not in progress (in auto
mode).
 TAS issues End Batch
command for authorized batch
which is not in progress (in auto
mode).
 DL8000 powers up for a
previously authorized batch
which was not in progress when
DL8000 powered down.
Note: If authorized batch was
running, flag resets.
Batch number reduces
by one.
 Clear Status command received
(in auto mode with 0Eh bit).
 Authorize Batch command
received (in auto mode).
 Batch authorizes (in manual
mode).
 Operating mode changes.
Batch Authorized
 Batch authorizes (in manual
mode).
 Authorize Batch command
received (in auto mode).
 Batch ends (sets 0Dh).
 Batch aborts.
 DL8000 powers up.