Emerson DL8000 - New;Unused Danload 6000 Exception Codes

DL8000 Preset Instruction Manual
Revised February-2016 Communications Protocols D-87
Exception # (hex value)
Description
5B
Tolerance Error
5C
Alarm active (for severity 2 and 3 alarms)
5D
Dependent user program is not in running state in
Preset
5E
Unable to reset or raise the alarm
5F
Max Transaction Total
60
Flow Rate Too Low/High
61
Weights and Measure locked
D.10 New/Unused DanLoad 6000 Exception Codes
The following exception codes have been added to the DanLoad 6000
protocol to support the DL8000. These codes are not present in the
original DanLoad 6000 protocol.
Table D-6. New/Unused DanLoad 6000 Exception Codes
Exception # (hex value)
Description
56
Recipe Verification Fail
57
Maximum batches delivered for transaction
58
Invalid alarm ID
59
No string data to display
5A
In Program mode
5B
Tolerance Error
5C
Alarm active (for severity 2 and 3 alarms)
5D
Dependent user program is not in running state
in Preset
5E
Unable to reset or raise the alarm
5F
Max Transaction Total
60
Flow Rate Too Low/High
61
Weights and Measure locked
62
Invalid History Record
The following exception codes, present in the original DanLoad 6000
protocol, are not used with the DL8000.
Exception # (hex value)
Description
11
Program code value is read only (not supported)
1B
Diagnostic not started. (not implemented)
20
Number of recipes less than 2 (not implemented)
46
Invalid CPU number (not implemented)
4A
Invalid I/O point type (not implemented)
52
Invalid data code (not implemented)