Emerson DL8000 - Alarm Logs; Meter Factor

DL8000 Preset Instruction Manual
D-88 Communications Protocols Revised February-2016
D.11 Alarm Logs
The DL8000 uses the following alarms.
Table D-7. Alarm Logs
Alarm Name Alarm ID Name in Event Log
Unable to maintain blend 0 Blend Fail X
Configuration corrupted 1 Config corrupt
Parameter restored 2 Param restored
Over flow preset quantity 3 O.F. preset
Meter factor deviation – Meter
X
4 MF Dev XXXX
Internal temperature failure 5 Intl temp fail
Linearization alarm – Meter X 6 Linr fail XXXX
System alarm – check log 7 System alarm
Safety Circuit1 8
Safety Circuit2 9
Safety Circuit3 10
Safety Circuit4 11
Safety Circuit5 12
Safety Circuit6 13
Safety Circuit7 14
Safety Circuit8 15
Instantaneous Blend X 16 Inst blend X
NaN found 17 NaN found
Data Error Found 17 Data Err Found
Note: Supported only in
Version 2.20 and greater.
Power failure 19 Power failure
Storage memory full 20 Stor mem full
Oup config corrupt 21 Oup conf corr
Oup parameter restored 22 Oup param rest
Storage memory pre-full 23 Sto mem pre
Note: Supported only in
Version 2.0 and greater.
Archive Error 24 Archive Error
Print Error 25 Print Error
K & D Com. Fail 26 KD Comm Fail
Group Alarm Name
Alarm ID
Name in Event Log
Flow rate too low – meter X
95 +
meter no
Low Flow X