Emerson DL8000 - Class I DIV 2 Housing

DL8000 Preset Instruction Manual
Revised February-2016 Installation and Use 2-5
Figure 2-3. Bolt Tightening Sequence
2.1.3 11BClass I Div 2 Housing
The Class I, Division 2 housing includes a 14-gauge stainless steel box
with 12-gauge stainless steel mounting flanges. The door is made of
.090 inch thick aluminum and is secured to the box via a stainless steel
piano hinge and two stainless steel spring latches. The latches include
features for padlocking or installing wire seals. The assembly includes a
door stop that locks the door in position at approximately 120 degrees
from the closed position. The viewing window in the enclosure door is
made from scratch / UV resistant polycarbonate/acrylic blend
(PC/PMMA). The keypad bezel is mounted to the front of the door and
is made from UV resistant polycarbonate. The assembly is rated by
CSA as a Type 4 enclosure, and can be either pole-mounted or flush-
mounted.
8
2
11
15
1
5
9
13
7
12
16
3
4
6
10
14