Emerson DL8000 - Page 180

DL8000 Preset Instruction Manual
D-52 Communications Protocols Revised February-2016
Display Message
[0x1C]
Deviations
 The DanLoad 6000 has capacity to display a
128-character long text message. The DL8000
supports the first 20 characters of text
message received.
 In the DanLoad 6000, if prompt field width is
greater than 0, the timeout timer is started
again whenever a key is pressed. If prompt
field width is zero, a timeout occurs after the
specified timeout time. In the DL8000, the
prompt field width does not affect the timeout
time.
Request
Keypad Data
[0x1D]
Retrieves input requested via Display Message command [0x1C]. When
keypad input is terminated, the DL8000 sets a flag to indicate that the keypad
data is available.
Flags Immediately Set
None
Flags Immediately
Cleared
None
Exceptions
 Batch in progress
 Primary alarm active
 No keypad data available
 Operating mode is manual
Supporting
Parameters
None
Results
Value stored at [63,0,177] is returned in response.
Deviations
None