DL8000 Preset Instruction Manual
Revised February-2016 DL8000 Keypad Display E-17
Press ENTER to continue. The program displays the Current Status
menu:
System
Stream
Additive
Meter
General
Batch
Transaction
Recipe
Alarm
The keypad display program does not display all the TLPs in the preset.
The program maintains a database which decides which TLPs you can
access through the Current Status menu and under which submenu those
TLPs reside. A TLP can be associated with any program or firmware.
Table E-6 shows which TLPs are available under which menu option.
Note: When the keypad display program is using the
Setup/Configuration, Current Status, Calibration, or Diagnostics
menu and an alarm occurs, the red LED blinks but no message
displays.
Table E-6. TLPs in Current Status Menus
SYSTEM Menu
General
(1 logical, point type 63)
Headings (Submenu Page 1)
Trans No. 63,0,20
Batch No. 63,0,22
LastPowerDownTime 63,0,21
Current Alarm Type 63,0,9
Roll Over Lmt 63,0,16
Batch
(1 logical, point types 63 & 64)
Headings (Submenu Page 1) TLP
Batch Number 63,0,125
BtchStart DateTime 63,0,232
Btch End Date Time 63,0,233
Batch Gross Del. 63,0,135
Batch Mass Del. 63,0,138
Btch Net Std. Del. 63,0,137
Headings (Submenu Page 2) TLP
Temp FWA 63,0,132
Base Dens. FWA 63,0,179
SwingArm Curr Side 63,0,145
Net Mass Btch Tot 63,0,25
Blend Curr Flowrate 63,0,59
Cmpt Batch GrsDel 63,0,2
To Next Page
Loading...
