Emerson DL8000 - Page 301

DL8000 Preset Instruction Manual
Revised February-2016 DL8000 Keypad Display E-83

14/03/12 12:26:02
Test AO Ch
Use AI Ch
(SELECT)
AO ch 1
AI ch 1
Note: For an external source, select NONE.
 14/03/12 12:26:02
Test AO Ch
Use AI Ch
(SELECT)
AO ch 1
NONE
Press ENTER to proceed. The system displays the AO EU value range
(high and low values) and the AI EU value range (high and low values).
This enables you to define a signal within the valid range.

14/03/12 12:26:02
Test AO Ch
Use AI Ch
AO EU value range ->
AI EU value range ->
(ENTER to continue)
AO ch 1
AI ch 1
0.000 to 100.000
0.000 to 100.000
EXIT to Go Back
Note: If you are using an external resource for analog input, the system
displays only the AO EU value range:

14/03/12 12:26:02
Test AO Ch
Use AI Ch
AO EU value range ->
(ENTER to continue)
AO ch 1
AI ch 1
0.000 to 100.000
EXIT to Go Back
Press ENTER. The system prompts you to provide a value for the
selected AO range. The system changes the displayed AI values in
response to the AO value you enter.
(Press EXIT to redisplay the AO channel selection screen.)