Emerson DL8000 - Page 316

DL8000 Preset Instruction Manual
E-98 DL8000 Keypad Display Revised February-2016

14/03/12 12:26:02
Sel Main Ch
(SELECT)
RS485 ch 4
ENTER to Continue
EXIT to Quit
Press ENTER to continue (or press EXIT to redisplay the main
Configuration menu). The system prompts you to select a test channel.

14/03/12 12:26:02
Sel Main Ch
SEl Test Ch
(SELECT)
RS485 ch 4
RS485 ch 5
ENTER to Continue
EXIT to Quit
If the installed RS-485 module is currently assigned to an application
(and therefore unavailable to test), the following message displays:

14/03/12 12:26:02
EXIT To Go Back
Card assgn to Appn
Press EXIT to end the test process. Once you un-assign the module, you
can restart the test.
If only one RS-485 module is installed, the following message displays:
 14/03/12 12:26:02
EXIT To Go Back
Single card in system
Need two cards
Press EXIT to end the test process. Once you install a second RS-485
module, you can restart the test.