Error Code Trip Description
39 User program stack overflow
40 Unknown error - please contact supplier
41 Parameter does not exist
42 Attempt to write to a read-only parameter
43 Attempt to read from a write-only parameter
44 Parameter value out of range
45 Invalid synchronisation modes
46 Unused
47 Synchronisation lost with CTSync Master
48 RS485 not in user mode
49 Invalid RS485 configuration
50 Maths error - divide by zero or overflow
51 Array index out of range
52 Control word user trip
53 DPL program incompatible with target
54 DPL task overrun
55 Unused
56 Invalid timer unit configuration
57 Function block does not exist
58 Flash PLC Storage corrupt
59 Drive rejected application module as Sync master
60 CTNet hardware failure. Please contact your supplier
61 CTNet invalid configuration
62 CTNet invalid baud-rate
63 CTNet invalid node ID
64 Digital Output overload
65 Invalid function block parameter(s)
66 User heap too large
67 RAM file does not exist or a non-RAM file id has been specified
68 The RAM file specified is not associated to an array
69 Failed to update drive parameter database cache in Flash memory
70 User program downloaded while drive enabled
71 Failed to change drive mode
72 Invalid CTNet buffer operation
73 Fast parameter initialisation failure
74 Over-temperature
75 Hardware unavailable
76 Module type cannot be resolved. Module is not recognised.
77 Inter-option module comms error with module in slot 1
78 Inter-option module comms error with module in slot 2
79 Inter-option module comms error with module in slot 3
80 Inter-option module comms error with module unknown slot
81 APC internal error
82 Communications to drive faulty
To Next Page
Loading...
