Enterasys RoamAbout RBT-4102 - Page 36

Initial Setup Using the CLI
3-10 Initial Configuration
c. SpecifyanewpasswordinthePasswordfield.
d. SpecifythenewpasswordagainintheConfirmPasswordfield.
e. ClickApplyatthebottomofthepage.
TheaccesspointdisplaysaSettingsSavedmessage.
f. ClickOK.
7. TospecifythemanagementVLANID:
a. ClickFilterControlfromthemenu.
TheFilterControlpageappears.
b. Click
theManage mentVLANID:fieldandentertheVLANIDfromwhichyouwill
managetheAP.
ThemanagementVLANisformanagingtheaccesspoint.Forexample,theaccesspoint
allowstrafficthatistaggedwiththespecifiedVLANtomanagetheaccesspointvia
remotemanagement,SSH,SNMP,
Telnet,andsoforth.VLANmanagementisenabledby
default,andcannotbedisabled.
c. ClickApplyatthebottomofthepage.
8. GotoChapter 4foradvancedconfiguration.
Note: You must set up the network switch port to support tagged VLAN packets from the
access point. The switch port must also be configured to accept the access point’s
management VLAN ID and native VLAN IDs.