1-33
Setting Up the Printer | 33
5. Remove any packing tape from the printer. Be sure to check underneath
and on the sides.
6. Open the front cover. Then unscrew the bolt and remove the bracket
securing the print head, as shown above. Save these parts in case you
need to ship the printer.
7. Close the front cover.
8. Raise the stabilizer knobs and unlock the casters. Then move the printer
to the place of use. (The casters are meant for moving the printer for
only a short distance.) Lock the casters and extend the stabilizer knobs
after moving.
To Next Page
Loading...
