Settings for NetWare Server
129
7
7
7
7
7
7
7
7
7
7
7
7
Note on using the Adobe PostScript 3 Kit:
If you have selected Remote (rprinter on IPX) for the first Printer
Agent, be sure to select Remote (LPR on IP) for the second Printer
Agent.
5. Configure it as described below. It is a good idea to print a
networkstatussheetofthe Internal PrintServer andconfigure
the corresponding items.
❏
For Remote (rpinter on IPX) connection:
You need to use the same configuration of NetWare
Remote printer mode as you have set by using EpsonNet
WinAssist already
.
IPX Network Number:
Enter the IPX network number of
the Internal Print Server.
IPX Node Number:
Enter the IPX node number of the
Internal Print Server.
SAP Name:
Enter the Primary Print Server Name. Do not
use the following characters: ~ ! @ # $ % ^ & * ( ) + ` = { }
[]|\:;"'<,>.?/`
Printer Number:
Entertheprinterportnumber(from0
to 254).
❏
For Remote (LPR on IP) connection:
IP Address:
Enter the IP address of the Internal Print
Server. You can confirm the IP address on the network
status sheet.
To Next Page
Loading...
