Settings for NetWare Server
133
7
7
7
7
7
7
7
7
7
7
7
7
Using a dial-up network in each mode
Print Server mode
You must use a dedicated dial-up line.
Since polling is performed on the file server in the print server
mode, no vicarious response by the router is possible.
Therefore, no dial-up connection is possible in this case.
Remote Printer mode
In Remote Printer mode, use of a router with a vicarious
response function allows the primary server to be installed at
the dial-up destination. However, an extra account might be
generated when the primary server is down. To avoid that, it
is recommend to use connections via a dedicated dial-up line.
Follow the instructions for using a dial-up line.
When there is a primary server at the dial-up
destination
For local networks with file servers:
❏
When the power is turned on
A dial-up is generated because access is made to a local file
server first and then to a primary server. There is no problem
since this dial-up only occurs at startup.
❏
When the Internal Print Server is not correctly set
Local network
Printer
File
server
Dial-up
router
Dial-up
router
Primary file server
(primary print server)
Remote network
To Next Page
Loading...
