Epson AcuLaser C8600 - Chapter 2 Easy Setup for Windows; Easy Setup Procedures

Easy Setup for Windows Me/98/95
15
2
2
2
2
2
2
2
2
2
2
2
2
Chapter 2
Easy Setup for Windows Me/98/95
Easy Setup Procedures
This chapter describes how Windows Me/98/95 users can easily
set up the printer on the network. TCP/IP printing is
recommended here.
To set up the printer on the network, install the necessary
protocols and the printer driver, using the following general
procedure.
1. Set up your printer. See the
Reference Guide
for details.
2. Install the TCP/IP protocol on the computer used for
configuring the Internal Print Server. Also, set the IP address
and the subnet mask. If there is a router on the network, set
the gateway address as well.
3. Use an Ethernet cable to connect your printer to the network.
4. Use EpsonNet WinAssist EasySetup to set the IP address of
the Internal Print Server.
5. For client:
Install the TCP/IP protocol on the client computer and set the
IP address and the subnet mask. If there is a router on the
network, set the gateway address as well. Also, install the
printer driver and the EpsonNet Direct Print utility that
enables TCP/IP printing.