EpsonNet WinAssist Configuration Utility
51
4
4
4
4
4
4
4
4
4
4
4
4
NetWare
To use the printer in the NetWare environment, configure the
InternalPrint Serveron thisscreen. Youcan configurethe Internal
Print Server either in Print Server mode or Remote Printer mode.
Note:
❏
Log in to the NetWare server or the NDS context with supervisor
privileges.
❏
If the current login environment is different from the current
configuration of the Internal Print Server, a message appears when
you run EpsonNet WinAssist. If you do not want to change the
current Internal Print Server configuration, click Cancel and log
in to the NetWare server or the NDS context with the same mode
set to the Internal Print Server again.
Items Explanations
Get IP address Select a method for acquiring IP addresses.
Set by PING Enables or disables IP address setting using the ping
command.
IP address Enter an IP address for the Internal Print Server. Be
sure that the IP address is unique and does not
conflict with any other device on the network.
Subnet mask Enter the subnet mask of the IP address.
Default gateway Enter the gateway address.
Use a private IP address
when an IP address
cannot be assigned by
the DHCP server
Select this check box to assign an private IP address
automatically without using the DHCP server on your
network.
Universal Plug and Play Enables or disables the Universal Plug and Play.
Universal Plug and Play
device name
Enter the device name for the Universal Plug and
Play.
To Next Page
Loading...
